Tips Installing Nautical Cabinet Hardware

0

Nautical Cabinet Hardware – Determine where to place the control of the cabinet doors. Set the hardware on the bottom of the door to make the cabinets above. Install the controls near the top of the door for lower cabinets. Assess the length of the box with a tape measure. To install a knob in the middle of the box, divide the length by two. Measure that level down from the top of the cabinet and draw a horizontal mark with a pencil.

If necessary, use a Phillips screwdriver to tighten the rest of the way.  To install a nautical cabinet hardware on the bottom of the box, height two inches from the bottom edge. Where the two lines intersect measure two inches from the side where the doors open and mark the place.

See Also:  Tab Pull Cabinet

Start at the edge of the box, where the door is opened and measured in a couple of inches and place a vertical mark. Where the two lines intersect place a mark. Make holes for the nautical cabinet hardware of those marks you made and make sure the drill bit is the same size as the knob bolt. Go all the way through the wood and back again. Push on the screw through the back of the hole, so that it comes out through the front of the door. Mount the knob on the end of the screw and hand tighten.

These are reader choosen ideas nautical cabinet hardware

Share.

Comments are closed.